The soap mixture can be made of a mild liquid detergent and water. For the stubborn stain, you will need a hose, a spray bottle with a soapy water solution, and a soft brush. It is best to clean any stain as soon as it occurs, as it will get harder to remove the stain as time goes on. If you find you have stubborn dirt, mold or mildew stains in certain areas of the lattice, you will need to treat and lightly scrub these areas. Periodic rinsing with a hose is typically all that’s needed to remove surface dirt and keep you lattice looking new. There will not be any sealing, painting or staining of the vinyl lattice so all we need to do is clean it. This makes vinyl lattice one of the easiest things to keep on the property. Avoid rainy days to stain or paint your lattice so there will be enough time for the lattice to dry completely.ĭepending on the type of vinyl lattice you chose, it is usually low in maintenance and season preparation. If staining is your preference, look for a stain that has the longest manufacturer’s warranty, has a water repellent and a UV stabilizer. You can brush, roll, or spray the paint on. If you choose paint, purchase a good exterior paint in a semi-gloss finish. Now you are ready to “finish” the lattice with stain or paint. When you buy a sealer, get one that is a good quality and has high resin content. You should not try to stain or paint a raw wooden lattice without priming it first. Next you should use a quality primer to seal the wooden lattice. This is an important step because it helps the pores of the wood to absorb the sealant, paint or stain. Scrape off any remaining loose paint and sand the wood to even the surface. After scrubbing the panel, rinse with fresh water to remove the residue. Or you can use a brush and a solution of water and chlorine bleach to scrub the panel. You will first need to remove the dirt with a pressure washer. If the lath is broken, as shown in the picture above, you may need to replace that entire panel, or construct a lath that can be attached in its place. If the strips are loose, nail/secure the strip back in place. Are the laths loose or falling off? Is it dirty? Did the paint peel?įirst things first, start by repairing any damage to the lattice panel. To extend the life of the product, careful attention should be paid to the current condition of your wooden lattice. Here are a few tips for maintaining and preparing your lattice for the summer. With all the time and effort used to establish the perfect outdoor room or enclosure, no one wants to see it degrade over time and allow the poor condition to reduce the value of their home. Cleaning should be included in your maintenance program as well.
The decision to use lattice in your outdoor area created the look you wanted and enhanced the beauty of your home.ĭepending on the type of lattice you installed, you may have some maintenance to do in order extend the look and life of the product.
0 kommentar(er)
